HVAC Appliances

Products / HVAC Appliances

Energycraft™ Natural Gas Heating & Cooling Appliances

Maximum Efficiency

Minimizing heating and cooling loads comes first, however, we've designed and assembled our appliances to the maximum efficiency possible. Our gas heaters are 95% efficient. The efficiency of the cooling compressor depends upon the Seasonal Energy Efficiency Rating, or SEER. The higher the SEER, the more efficient the cooling equipment runs. We offer an extremely efficient 14 and 16 SEER condenser on all standard models. The standard cooling capacity of the EnergyCraft Cooling Appliances is approximately 55,000 BTU/hr, and cools at 14 or 16 BTU/watt of electricity used. Thermal Design provides free sizing of HVAC equipment and energy calculations. Nation wide service is available.

Ease of Installation

We've specifically designed our HVAC units to be self-contained appliances that are fast and simple to install. These units come pre-wired and pre-plumbed, “ready-to-run”. Simple unpack the unit, position the appliance, and secure it in place. Plug the appliance into a suitable receptacle, run the condensate line and begin using the appliance. Ideal installation should total less than two hours for two people. Check with applicable codes and regulations that apply to your project.

Horizontal Wall Mount Appliance

Horizontal Wall Mount Appliance

When floor space is important, our Horizontal HVAC Appliance is ideal. It mounts above the floor and out of the way of activity. Simply slide it through the framed opening, fasten and seal it! A framed opening from the building manufacturer provides best results. Although framing kits are available for wall installations, jamb, sill, and header trim should be from the building manufacturer so it matches your building trim.

 

Vertical Floor Mount Appliance

Horizontal Wall Mount Appliance

The EnergyCraft Vertical HVAC appliance does not require a framing kit for installation yet delivers the same high efficiency. Vertical appliances have compact footprints and require only a small opening for the AC condenser platform. Simply position the appliance with the condenser cantilevering outside of the building wall as indicated. Wall sheeting is attached to the wall box using galvanized building trim.

 

Air Flow

Optional air intake kits are adjustable for up to 20% heater fan CFM for a healthy fresh air exchange. Powered exhaust fans must match intake air to balance the air pressure with the exterior. Proper design keeps humidity out of the roof and wall insulation cavities, and helps prevent condensation and needless energy loss.

Heat Pump

Heat pump models that operate even more efficiently in heating mode than straight resistance heating are also available. Heat pumps operate by capturing heat out of the exterior air and releasing it in the inside air. In the cooling mode, valves reverse the process and operate similar to conventional air conditioning appliances.

Specification Overview

EnergyCraft Heating and Cooling (Gas)

Specification values are typical data subject to normal manufacturing  variations and are not meant to be guaranteed or limiting  specifications. Thermal Design, Inc. reserves the right to improve and  change component specifications without notice.

Unit Configuration Heating BTUs Cooling BTU & SEER Dimensions (HxWxD) Footprint
Horizontal 98,000/109,000 56,000 & 14/16 SEER 45 1/2" x 87 1/4" x 84" N/A Wallmount
Vertical 98,000/109,000 56,000 & 14/16 SEER 90” x 36” x 87 1/4” <22 sq. ft.

All units are single phase, 96% efficient, and are available as split systems (dimensions vary). EnergyCraft Natural Gas/Propane Heating Appliances are optimized for use with the Simple Saver System. Performance not guaranteed if combined with different insulation methods or products from Thermal Design.


Join our mailing list